Tutaj nawet komputera nie trzeba żeby zdiagnozować keyless system :
1 : sprawdzenie lampki immo/ kluczyka
Key Indicator Lamp Check
Push the ignition knob switch (2) of the steering lock unit (1) and check that the key indicator lamp (3) in the combination meter lights up in red or blue. If it does not light, go to “Key Indicator Lamp Circuit Check (Key indicator lamp doesn’t light when ignition knob switch is pushed.)”.
2: sprawdzenie błędów keyless
DTC Check
1) Check to make sure that all doors are closed.
2) Open driver side door window glass and door.
3) Check to make sure that ignition key is not inserted in ignition key cylinder. If it is, remove it.
4) Perform “Key Indicator Lamp Check”.
5) Close driver side door and within 15 seconds after that, perform Steps a) through e) described below. a) Insert ignition key (1) in ignition key cylinder (2). b) Remove ignition key from ignition key cylinder. c) Repeat Steps a) and b) twice. d) Insert ignition key in ignition key cylinder. e) Push driver side door request switch (3) 4 times. At the end of Step e), buzzer sounds 4 times to inform that trouble diagnosis mode has started.
6) Read flashing pattern of key indicator lamp (1) which represents DTC as shown in example below and write it down. When more than 2 DTCs are stored in memory, flashing for each DTC is repeated three times starting with the smallest DTC number in increasing order.
Jedna sprawa jeszcze.
Jak naciskasz przyciski na pilocie to świeci się dioda w nim ?
